The recommended tire pressure for a Chevy Spark can range from 30 to 40 pounds per square inch (PSI), depending on the model year.
Improperly inflated tires can come with costly consequences. Under-inflated tires can not only reduce your fuel economy, but they can also make it harder to steer your vehicle and reduce traction. And both over- and under-inflated tires can put you at risk of a blowout, meaning you’d have to replace your tires sooner than planned.
Luckily, maintaining your tire pressure isn’t as difficult as it sounds—especially when compared to other kinds of car maintenance. Courtesy of the car insurance
comparison app Jerry
, here’s what to know about your Chevy Spark’s tire pressure recommendations—as well as how to save on your Chevrolet insurance costs.
What is the right tire pressure for a Chevy Spark?
Tire pressure requirements for the Chevrolet Spark vary by model year. However, recommendations generally fall between 30 and 40 psi for front and rear tires.
To confirm your own Spark’s pressure requirements, you can check:
The label found on your driver's side door jamb
The sidewalls of the tires themselves
If your tires are a different size than the ones that came standard with your vehicle, you’ll need to reference those specific tires’ inflation requirements.
Tire pressure recommendations for other Chevrolet vehicles
Here’s how the tire pressure recommendations for other Chevrolet vehicles compare:
Again, though, remember to check your own vehicle and tire specifications to determine the correct tire pressure for you.
MORE: How low can your tire pressure go?
How to check Chevy Spark tire pressure
Even with a tire pressure monitoring system (TPMS), it’s always a good idea to double-check your pressure levels with a tire pressure gauge
from time to time—especially if your vehicle feels uneven when you drive or more challenging to handle. If you don’t have one of your own, you can typically find them at gas stations with air-filling stations. To use one, unscrew the valve stem cap on the tire and apply the tire pressure gauge to the valve stem to get your reading. It’s recommended to do this when the tires are cold—ideally when you’ve driven under a mile and your tires haven’t been sitting in direct sunlight for a few hours.
Once you have your reading, you can add and release air from the tire as needed.
How often should you check tire pressure?
It’s commonly recommended that you check your tire pressure monthly, as well as:
When your vehicle’s load significantly changes
When your driving or environmental conditions change
How to tell if your Chevy Spark needs new tires
Depending on how often you drive, your driving style, and typical driving conditions, you could expect to change your Chevrolet Spark’s tires every two to six years.
Unsure when to get new tires? Keep an eye out for these warning signs:
Low tread depth (especially when below 4 mm)
Tires won’t hold consistent pressure
How to reset the Chevy Spark tire pressure monitoring system (TPMS) light
The job of your vehicle’s tire pressure monitoring system (TPMS) is exactly what it sounds like: it monitors the pressure in each of your tires and then it alerts you when the pressure is too low.
Even if you’ve properly inflated your tires after your TPMS light has illuminated on your dashboard, it’s possible the light might remain on—in which case you might need to reset your TPMS
. Usually, your TPMS should recalibrate itself after you’ve driven 50 mph or faster (where legal, of course) for over ten minutes. But if you need to reset it manually, here’s what you can do:
Turn your key to the “on” position in your ignition without starting the engine
Press and hold the TPMS reset button until the TPMS light flashes three times (your owner’s manual can help you locate the button if you can’t find it)
Start your vehicle—the TPMS should reset after roughly 20 minutes of driving
If you still can’t get the TPMS light to turn off after this, there could be an issue somewhere in the system, like a faulty sensor, that might need the attention of a mechanic.
How to save on Chevy Spark insurance
Keeping your tires properly inflated year-round will help them last longer, saving you a good amount of money in the long run. Another easy way to save on car ownership expenses is to make sure you don’t overpay for your Chevrolet Spark insurance costs
. Luckily, the Jerry
app makes that easy. It only takes about 45 seconds to answer a few basic questions. From there, Jerry will gather the most competitive quotes from over 50 of the nation’s top providers. When you find the right coverage at the best rate, Jerry can even help you with the phone calls and paperwork that can come with switching to a new policy.
Maintaining correct tire pressure is a great way to save on car-related expenses. By checking your tire pressure regularly, you’re improving fuel efficiency and helping to avoid potentially costly accidents.
When all is said and done, the average driver who makes a switch with Jerry saves over $800 per year on their car insurance
! “A seamless process and a fantastic app! Jerry
saved me over $2,000 on car insurance. I would recommend it to anyone and everyone.” —Osvaldo B.
RECOMMENDEDThis app is great, but the customer service is even better! Not to mention convenient! My husband and I got the lowest rate (much lower than the rates I was finding online through my own searches), quickly, and pretty much all through text message! Thank you so much for a hassle free experience👍